10-21-2017, 07:46 PM
(This post was last modified: 01-05-2018, 03:48 PM by Microdesignum.)
Q: How to configure MIDI Grande for controlling Kemper Profiling Amplifier?
A: We will show a configuration example on MIDI Grande 10F1D model. It is similar on other models.
1. Globally configure MIDI Grande:
Send 2 commands per each layer:
Command 1: PC (Program Change)
Command 2: CC (Control Change)
Set the registers:
Registers 1-5: Program (PGM) mode
Registers 6, A and : Stompbox (STO) mode
2. Set the layers in the first bank:
Register 6: Tap tempo - it is controlled by CC#30 on Kemper Profiler
Register A: Reverb - it is controlled by CC#29 on Kemper Profiler
Register B: Delay - it is controlled by CC#27 on Kemper Profiler
Registers 1-5 remain on default settings without changes: PC#1 to PC#5
You also have to assign the rigs on your Kemper Profiler to MIDI programs 1-5.
3. Enable the bidirectional communication:
A: We will show a configuration example on MIDI Grande 10F1D model. It is similar on other models.
1. Globally configure MIDI Grande:
Send 2 commands per each layer:
Command 1: PC (Program Change)
Command 2: CC (Control Change)
Set the registers:
Registers 1-5: Program (PGM) mode
Registers 6, A and : Stompbox (STO) mode
2. Set the layers in the first bank:
Register 6: Tap tempo - it is controlled by CC#30 on Kemper Profiler
Register A: Reverb - it is controlled by CC#29 on Kemper Profiler
Register B: Delay - it is controlled by CC#27 on Kemper Profiler
Registers 1-5 remain on default settings without changes: PC#1 to PC#5
You also have to assign the rigs on your Kemper Profiler to MIDI programs 1-5.
3. Enable the bidirectional communication: